Location And Installation - hestan KSO 30 Mode D'emploi

LOCATION AND INSTALLATION

UNPACKING AND PLACEMENT
Remove the outer carton and packing materials from the shipping pallet. Do not remove the
plastic film covering the stainless-steel surfaces. This film protects the finish from scratches
until the appliance is installed in its final position.
The unit is very heavy and should be handled with care. Use proper safety equipment, such as
gloves, and at least 2 persons to move the appliance into position to avoid injury and to avoid
damage to the floor or the appliance itself.
DO NOT USE A HAND TRUCK OR DOLLY ON THE FRONT OR REAR
OF THE OVEN. HANDLE AND MOVE FROM THE SIDES ONLY.
Do not lift or carry the appliance by the oven door or handle. This could damage the door
hinges. Use handles on either side of oven.
PREPARATION
Before moving the oven, protect any finished flooring and remove or secure the oven door(s)
closed to prevent damage. DO NOT lift the oven by the door handle. See "OVEN DOOR
REMOVAL" on page 4 regarding door removal.
An approved junction box is to be installed where it will be easily reached through the front of
the cabinet where the oven will be located. The oven has 3 ft. [91 cm] of conduit, an allowance
of 2 to 3 ft. [61-91 cm] of slack in the line is recommended for future relocation.
• The oven support surface must be a minimum 3/4" [2 cm] plywood platform.
• For single ovens, it must support 202 pounds [92 kg].
• For double ovens, it must support 379 pounds [172 kg].
• The platform must be solid, level, and flush with the bottom of the cabinet cutout.
The oven should be located for convenient use in the kitchen, but away from strong drafts.
Drafts may be caused by open doors or windows, or by heating and/or air conditioning vents or
fans.
Make sure that electrical power can be provided to the location selected.
TOOLS
The following tools are needed for the installation of the oven:
• Tape measure and straight edge or ruler
• Pencil
• Philips screw driver
• Level
• Wire cutters and wire stripper
• Hand or saber saw
• 1" [2.5 cm] Hole saw
• Drill and drill bit
• Safety gloves and goggles
• Volt meter [0-250VAC]
©2019 Hestan Commercial Corporation
EN
3