Publicité
Les langues disponibles
Les langues disponibles
Assigning detectors to particular zones
1.
Put the expansion module into learn mode.
2.
Press the „SELECT" button until the required zone is displayed. If the
display flashes then the zone is not assigned (free). If the display is
constant then the zone is assigned.
3.
Now carry out steps 2 and 3 as described in „Teaching radio
components".
Deleting detectors
1.
Put the expansion module into learn mode.
2.
Press the „SELECT" button until the required zone is displayed.
3.
Press the „DELETE" button for approx. 4 seconds. A double beep is
emitted and the detector is deleted.
Deleting radio remote controls and panic alarms
These components can not be deleted individually. To delete a component, all
radio remote controls and panic alarms must be deleted.
1.
Put the expansion module into learn mode.
2.
Press the „SELECT" button until „
3.
Press the „DELETE" button for approx. 4 seconds. A double beep is
emitted and all radio remote controls and panic alarms are thereby
deleted.
Displaying the signal strength of a detector
1.
Put the expansion module into learn mode.
2.
Press the „SELECT" button until the required zone number or the radio
remote control/panic alarm number is displayed. Both LEDs on the
PCB should now be off.
3.
Activate the appropriate radio components. The green LED (Pass)
indicates that there is sufficient signal strength. The red LED (Fail)
indicates that there is insufficient signal strength. The signal strength
and zone number are displayed alternately.
" is displayed.
11
Publicité
