Publicité
Les langues disponibles
Les langues disponibles
Programming the radio expansion module
Setting the learn mode
To put the expansion module into learn mode, the 12V DC supply must be
connected (from the BUS or a separate supply). As soon as all detectors have
been programmed into the module („taught") they are stored permanently,
even if there is a power failure or the power is removed.
As soon as the power supply is connected, the first message „88" appears in
the display.
To enter learn mode, simply open the tamper switch (remove the front cover)
and then press the „SELECT" button. The display now shows: The module is
now in learn mode.
IMPORTANT: You must leave the learn mode of the expansion module before
removing the power supply.
Teaching radio components
1.
Put the expansion module into learn mode if you have not already
done so.
2.
Make sure that the LED of the radio components to be taught points
to the learn sensor at a maximum distance of 100 mm.
3.
Activate the radio components (when necessary by releasing the
tamper switch). The LED must thereby point to the learn sensor of the
expansion module.
The expansion module emits a double beep when the radio
component has been successfully taught. Detectors that have been
taught now show the signal strength on the left (max. 9) and the
channel number on the right. The channel is assigned automatically.
A taught panic alarm or remote control shows the number of learnt
components by displaying„
If the radio component can not be taught then the expansion module
emits a single beep.
4.
Repeat steps 2 and 3 to teach additional radio components. Please
observe that a maximum of 6 radio remote controls or panic alarms
can be taught.
„ alternately to the signal strength.
10
Publicité
