Connecting Audio; Connecting Alarms; Connecting The Power - Eneo IPP-82A0030MHA Mode D'emploi

Connecting Audio

Connect speaker to audio output line and external mic to audio input line.

Connecting Alarms

A1,A2,A3,A4 (Alarm Input 1,2,3,4)
You can use external devices to signal the camera to react on events. Mechanical or
electrical switches can be wired to the A1,A2,A3,A4 (Alarm Input 1,2,3,4) and G (Ground)
connectors.
G (Ground)
Notice: All the connectors marked G or GND are common.
i
Connect the ground side of the alarm input and/or alarm output to the G (Ground)
connector.
AO (Alarm Output)
The camera can activate external devices such as buzzers or lights. Connect the device to
the AO (Alarm Output) and G (Ground) connectors.

Connecting the Power

Connect power of 12VDC for the camera.
When using a 12VDC adapter, connect the positive (+) pole to the ' + ' position and the
negative (-) pole to the ' - ' position.
Use satisfy clause 2.5 of IEC60950-1/UL60950-1 or Certified/Listed Class 2 power source
only.
• Be careful not to reverse the polarity when you connect the power cable.
If you use PoE to supply power to the camera, you must use the PoE (Power over Ether-
net) injector provided with the camera.
EN
11