Publicité
Les langues disponibles
Les langues disponibles
DAILY USE
USING THE HOOD
Check the recommended speed according to the
table below.
It is recommended to leave the hood
operating for approximately 15
minutes after cooking.
To operate the hood:
1. Press the first speed button
the appliance.
2. If needed, press the light button
illuminate the cooking surface.
3. If needed, change the speed by pressing the
desired button.
To turn off the appliance press the first speed
button
again.
HOB²HOOD FUNCTION
It is an automatic function which connects the hob
with a hood. Both the hob and the hood have an
infrared signal communicator. Speed of the fan is
defined automatically on basis of mode setting and
temperature of the hottest cookware on the hob.
You can also operate the fan using the hob
manually. The function can be activated from panel
of the hob.
For more information how to use the
function refer to the hob user manual.
FILTER NOTIFICATION
Filter alarm reminds to change or clean the
charcoal filter and clean the grease filter. The filter
indicator
is turned on for 30 seconds if the
While heating up food, cooking with covered pots.
While cooking with covered pots on multiple cooking zones or burners,
gentle frying.
While boiling, frying big quantities of food without a lid, cooking on multiple
cooking zones or burners.
While boiling, frying big quantities of food without a lid, big humidity. The
hood operates on maximum speed. After 6 minutes the appliance returns to
previous setting.
to switch on
to
grease filter must be cleaned. The filter indicator
flashes for 30 seconds if the charcoal filter must be
replaced or cleaned.
Refer to cleaning the grease filter in
care and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in care and
cleaning chapter.
To activate or deactivate function:
1. To activate function press the button
seconds.
If the function is activated, the filter indicator
flashes two times.
2. To deactivate function press the button
3 seconds.
If the function is deactivated, the filter indicator
flashes ones.
To reset the function press the button
seconds.
REMOTE-CONTROL
The appliance is supplied with a remote-control.
The connection is originally enabled.
To connect or disconnect remote-control:
1. Switch off the appliance.
2. Press the
for 3 seconds.
The indicator on control panel flashes twice if
function is enabled and once if disabled.
for 3
for
for 3
27
Publicité
