filtreau UVC OZONE 80W AMALGAM Manuel page 7

MAINTENANCE AND DISASSEMBLY
The device needs maintenance at least once per half year. During maintenance, the device must be disconnected
from the mains. Chalk deposits and possibly algae must be removed from the quartz sleeve (P) and the housing (D).
The UV-C Ozone lamp (O) only has to be changed after 8,000 hours of use. The actual lifetime is dependent on the
number of times it is turned on and off. The electronics will indicate when the lamp has been on for 8,000 hours.
1. Unplug the device from the mains and close the pipes.
2. Ensure that the water is drained out of the device.
3. Loosen the bolt (R) and disconnect the UV-C Ozone lamp (O) from the lamp holder (W). If necessary, you can also
replace the lamp (see point 10 to reset).
4. Carefully raise the quartz sleeve (P).
5. The quartz sleeve (P) can be cleaned with an appropriate cleaner. After cleaning, rinse the quartz sleeve (P)
thoroughly. Use a soft cloth to avoid scratches!
6. The housing (D) can now also be cleaned. This can be done with a brush; do not use any chemicals.
7. After cleaning, place the quartz sleeve (P) back in the housing (D). Ensure that the O-ring (Q1 & Q2) is seated
properly and that the quartz sleeve (P) slides into the sleeveholder (X).
8. Put the UV-C Ozone lamp (O) into the lamp fitting (W) and slide both into the quartz sleeve (P).
9. Tighten the nut (R) on the housing (D) hand-tight. (See 9 under Installation of the device).
10. After changing the UV-C Ozone lamp (O), the device needs to be reset. To do this, press and hold button (Y)
on the electronics box (T) for 5 seconds. After this the green light will come on.
N.B. To change the housing and/or the electronics box, the earth must be completely disconnected. The component
parts must be saved because they do not come with a new housing or electronics as standard.
If in any doubt seek the advice of a certified electrician!
GB
7