Cleaning, Maintenance And Storage; General Cleaning And Maintenance Work; Changing The Blade; Storage - Deltafox DG-ELM 1537 Traduction De La Notice D'utilisation Originale

ing backwards and pulling the equip-
ment.
• Clean the equipment after each use,
as described in the chapter on "Clean-
ing, Maintenance and Storage".
Switch off the equipment after
work and in order to transport it,
disconnect the plug and wait until
the blade stops. There is a risk of
injury.
Cleaning, Maintenance
and Storage
Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
Wear gloves when handling the
blade
Switch off the equipment before all
maintenance and cleaning work,
disconnect the plug and wait until
the blade stops.
General Cleaning and
Maintenance Work
Do not hose down the lawnmow-
er with water.
• Always keep the equipment clean. To
clean, use a brush or cloth but no de-
tergent or solvent.
• After mowing, use a piece of wood
or plastic to remove adherent plant
remains from the wheels, ventilation
holes, ejection hole and blade area.
Do not use hard or pointed objects, as
these may damage the blade.
• Oil the wheels from time to time.
• Before each use, check the lawnmow-
er for obvious defects such as loose,
worn or damaged parts. Check that all
nuts, bolts and screws are sitting firmly.
• Check the covers and protective de-
vices for damage and check that they
are sitting correctly. Replace them if
necessary.

Changing the Blade

If the blade is blunt, it can be sharpened
by a specialist workshop. If the blade is
damaged or showing signs of imbalance, it
must be replaced (see chapter on "Spare
Parts").
1. Turn the equipment over.
2. Use sturdy gloves and hold the
blade firmly (20). Turn the blade
screw (21) anticlockwise off of
the motor spindle using a screw-
driver.
3. Install the new blade in the re-
verse order. Ensure that the bla-
de is positioned correctly and the
screw tightened firmly.

Storage

The device features the following storage
options to save space:
1. Loosen the lower wing nuts (6).
2. Fold the lower bar (4) onto the
device housing (9).
Make sure that the cables do not
become trapped.
3. Tighten the wing nuts (6) by
hand.
4. Place the device upright (stow
function).
GB
29