Mowing; Working Instructions; Cleaning And Maintenance; Cleaning And Maintenance Workon The Underside Of The Appliance - Deltafox DG-PLM 5125 SP Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
Release the safety loop (2). The motor
switches off and the knife is braked.
The knife must stop within 7 seconds.

Mowing

1.
Start the engine (see „Starting
and Stopping the Engine").
2.
Wheel drive:
On: Pull the drive catch (26)
towards the handle bar (1). The
mower moves forwards.
Off: Release the drive catch (26).
The equipment stops.

Working instructions

As far as possible, mow the lawn when
it is dry in order to protect the turf.
Set the cutting height such that the
equipment is not overloaded.
Run the equipment at walking speed
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
Do not move backwards.
On slopes, always work across the
slope.
If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
Switch off the equipment during long-
er breaks and for transportation and
wait until the blade is stationary.
Clean the equipment after each use,
as described in the "cleaning and
maintenance" chapter.

Cleaning and maintenance

Ask our service centre to carry
out any work that is not descri-
bed in these instructions. Use
only original parts.
Carry out maintenance and
cleaning work strictly with the
engine switched off and spark
plug connectors removed. Risk
of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!
Wear gloves when handling the
blade.
Cleaning and maintenance
workon the underside of
the appliance:
Place an underlay under the petrol
lawnmower.
Do not tilt the equipment sideways
or forwards. Operating fluids could
leak out and the engine could be
damaged.
Make sure that a second person
holds the device because there is
a danger of tipping backwards.
1. Disconnect the spark plug
connector (
2. Remove the grass collection
box (
3. Unhook the starter handle and
rope (
4. Release the quick-release
levers (
handlebar (1).
15).
23).
25).
4) and fold up the
GB
113

Publicité

Table des Matières
loading

Table des Matières