Axis Communications M1145 Serie Guide D'installation page 19

2. Press and hold the control button and reconnect power. See
Hardware Overview on page 10.
3. Keep the control button pressed for 15–30 seconds until the
status LED indicator flashes amber.
4. Release the control button. The process is complete when the
status LED indicator turns green. The product has been reset to
the factory default settings. If no DHCP server is available on
the network, the default IP address is
5. Using the installation and management software tools, assign
an IP address, set the password, and access the video stream.
It is also possible to reset parameters to factory default via the web
interface. Go to Setup > System Options > Maintenance and click
Default.
Further Information
For the latest version of this document, see www.axis.com
The User Manual is available at www.axis.com
Visit www.axis.com/techsup to check if there is updated firmware available
for your network product. To see the currently installed firmware version,
go to Setup > About.
Visit Axis learning center www.axis.com/academy for useful trainings,
webinars, tutorials and guides.
Warranty Information
For information about Axis' product warranty and thereto related
information, see www.axis.com/warranty/
AXIS M1145 Series
192.168.0.90
19