Publicité
Les langues disponibles
Les langues disponibles
GAS HOSE
• If the hose and regulator are not included by the manufacturer, then only hoses and regulators which meet national and regional
codes are to be used.
• Do not connect the appliance to a permanent gas installation.
• Ensure that the hose does not come into contact with grease, other hot drippings, or any hot surfaces on the appliance.
• Check hose regularily. In the case of rips, melting or wear, replace hose before using the appliance.
• The recommended hose length is 0.7m. The hose must not be longer than 1.5m.
• Ensure that the hose is twist and kink free when installed.
• Replace the hose before expiry date printed on the hose.
REGULATOR
The following table lists input values for the appliance.
BURNER
Certified Gases / Pressures - Check rating plate to ensure that it corresponds with following list.
G as Category
O rific e S iz es (s ee above)
G as es / P res s ures
Countries
The regulators for both butane and propane must have a rating of at least 300 g/h. Do not tamper with or modify regulator. Use
only regulators which supply the pressure listed in the table above.
LEAK TESTING INSTRUCTIONS
LEAK TESTING: This must be done before initial use, annually and whenever any gas components are replaced or serviced. No smoking while
performing this test, and remove all sources of ignition. See Leak Testing Diagram for areas to check.
1. Connect the cylinder to the grill regulator, turn the cylinder valve on.
2. Brush a half and half solution of liquid soap and water onto the joint between the regulator and the cylinder, and where the regulator hose
connects to the valve on the grill.
3. Bubbles will indicate a gas leak. Either tighten the loose joint or replace the part with one recommended by the dealer.
4. If the leak cannot be stopped, shut off the valve on the cylinder, disconnect it and have the barbecue inspected by your gas supplier or dealer.
Do not use the appliance until the leak has been corrected.
5. Turn off gas supply.
ORIFICE SIZE
HEAT INPUT
I
II
(TOTAL)
#60
#64
4.1 kW
I
3B / P (30 )
I
Butane 30mbar
Propane 30mbar
DK , F I, NL, NO ,
S E , G R, IS , LU
DO NOT USE A FLAME TO LEAK TEST.
GAS USAGE (TOTAL)
PROPANE
BUTANE
293 g/h
298 g/h
I
3 +(2 8-3 0/ 3 7)
I
Butane 28-30mbar
Butane 50mbar
Pr opane 37mbar
Pr opane 50mbar
B E , E S , F R, G B ,
DE , A T
IE , IT, P T, CH, G R
I
3B / P (50 )
II
5
Publicité
