Using Instructions - ecofort ecoQ CleanAir 800 Manuel D'emploi

Using instructions

Filter Replacement
= Turn off air purifier and cut off the power. (Picture 1)
Note: If user switch the key to turn off the purifier, the
purifier is still in standby mode, user need to unplug
the power plug to cut off the power of the main unit.
= Grasp the buckle of the side cover, pull it out, and
take out the covers. (Picture 2)
= Take out the filters one by one.
= Remove filters one by one.
Wrap the discarded filter in a garbage bag to prevent
pollutants from the filter material from falling into the
room. (Picture 3)
(From Pre-filter To composite filter)
Note:
Please dispose of used filters as non-combustible
garbage. The pre-filter can be used repeatedly,
please wash by water and dry before continuing to
use it.
= Grasp the side covers, align with the groove at the
bottom of the machine, then close the top cover, plug
in and operate it. (Picture 4)
= Please reset the filter reminder function after
replacing the filter. (For detailed operation, please
refer to the detailed description on page 56)
Note:
1. Please read the filter replacement operation in detail to ensure the purification effect of the air purifier.
2. Before cleaning the air purifier system, unplug the power cord and cut off the power to the air purifier system.
3. Keep the inside of the air purifier dry to prevent damage to the circuit.
54 | User Manual ecoQ CleanAir 800
Picture 1
Picture 2
Picture 3
Picture 4