IMG STAGELINE TXS-820HSE Notice page 2

TXS-820HSE TXS-822HSE
Order No. 24.0890
Order No. 24.0880
Pocket Transmitter for
GB
Headband Microphone
HSE-100
863.05 / 864.80 MHz
Please read these instructions carefully prior to
setting the unit into operation and keep them for
later use.
1 Operating Elements and
Connections
1 Power LED
2 On/off switch
position ON: transmitter switched on
mid-position: transmitter mute
position OFF: transmitter switched off
3 Belt clip
4 Volume control
5 Jack for an electret headband microphone
with mini XLR connector,
e. g. HSE-110 by "img Stage Line",
for pin configuration see specifications
2 Applications
This pocket transmitter serves for connecting an
electret headband microphone (e. g. HSE-110
by "img Stage Line"). This system allows wire-
less transmission of music and speech to a re-
ceiver operating at the same frequency as the
transmitter. The range is approx. 30 m and de-
pends on local conditions.
It is possible to combine e. g. the following
receivers from the "img Stage Line" range with
the TXS-8..HSE transmitters:
suitable for
Type
TXS-820HSE
TXS-800
1-channel receiver
TXS-840
2-channel receiver TXS-860
2.1 Conformity and Approval
Herewith, MONACOR INTERNATIONAL de clare
that the units TXS-820HSE and TXS-822HSE
are in accordance with the basic re quirements
and the other relevant regulations of the direc-
tive 1999 / 5 / EC. The units are licence-free and
generally ap proved for operation in EU and
EFTA countries.
POWER VOL.
ON OFF
1 2 3 4 5
3 Safety Notes
G
The transmitter is suitable for indoor use only.
Protect it against dripping water and splash
water, high air humidity, and heat (admissible
ambient temperature range 0 – 40 °C).
G
For cleaning only use a dry, soft cloth, never
use chemicals or water.
G
No guarantee claims for the transmitter and
no liability for any resulting personal damage
or material damage will be accepted if the
transmitter is used for other purposes than
originally intended, if it is not correctly con-
nect ed, operated, or not repaired in an expert
way.
If the transmitter is to be put out of oper-
ation definitively, take it to a local recy-
cling plant for a disposal which is not
harmful to the environment.
Dead batteries or defective rechargeable bat-
teries do not belong in the household rubbish,
always take them to a special waste disposal
(e. g. collective container at your retailer).
4 Setting into Operation
1) Open the battery compartment. Insert a 9 V
battery with the positive and negative poles as
indicated in the battery compartment (fig. 2).
2) Fasten the transmitter on your belt by means
of the clip (3). If required, turn the clip by 90°
(locks into place). For this purpose, slightly
release the screw on the clip and then retight -
en it.
3) Put on the headband microphone and con-
nect it to the jack (5) on the transmitter.
4) Switch on the transmitter with the sliding
switch POWER (2). The red LED (1) lights up
as a power indicator. If it fails to light up or if
suitable for
it only shows a dim light, the battery is ex -
TXS-822HSE
haus ted and must be replaced.
TXS-802
Slide the switch POWER to the left stop to
TXS-842
position ON. In mid-position, the transmitter
is mute, i. e. it is switched on but no sound is
TXS-860
trans mitted.
5) Speak into the microphone. Advance the con-
trol VOL (4) to such an extent that the
receiver is not overloaded, i. e. that the trans-
mission signal is not distorted.
6) Remember to switch off the transmitter after
operation. If it is not used for a longer period
(e. g. more than a week), the battery should be
removed to prevent any damage to the trans-
mitter caused by potential battery leak age.
Œ
®
MONACOR INTERNATIONAL GmbH & Co. KG • Zum Falsch 36 • 28307 Bremen • Germany
©
Copyright by MONACOR INTERNATIONAL. All rights reserved.
5 Specifications
Carrier frequency
TXS-820HSE: . . . . . 863.05 MHz
TXS-822HSE: . . . . . 864.80 MHz
Transmitting power: . . < 5 mW (EIRP)
Frequency stability: . . ±0,005 %/25 °C,
Modulation: . . . . . . . . . FM, ±40 kHz
Audio frequency
range: . . . . . . . . . . . . . 50 – 15 000 Hz
Range: . . . . . . . . . . . . approx. 30 m
Ambient temperature: . 0 – 40 °C
Power supply: . . . . . . . 9 V battery
Dimensions: . . . . . . . . 66 × 108 × 35 mm
Weight: . . . . . . . . . . . . 100 g
Connection: . . . . . . . . mini XLR jack
1 = ground
2 = signal input
1 3
3 = 5 V operating voltage for
2
Subject to technical change.
9V

A-0464.99.04.07.2011
quartz-controlled
the microphone