Publicité
Les langues disponibles
Les langues disponibles
NOTE about LP Gas Tank Exchange Programs
Ÿ
Many retailers that sell grills offer you the option of
replacing your empty LP Gas tank through an exchange
service. Use only those reputable exchange companies
that inspect, precision fill, test and certify their tanks.
Exchange your tank only for an OPD safety feature-
equipped tank as described in the LP Gas tank section
of this manual.
Ÿ
Always keep new and exchanged LP Gas tanks in an
upright position during use, transit or storage.
Ÿ
Leak test new and exchange LP Gas tanks BEFORE
connecting one to your grill.
How to Leak Test your LP Gas Tank
For your safety:
Ÿ
All leak tests must be repeated each time your LP
Gas tank is exchanged of refilled.
Ÿ
When checking for gas leaks do not smoke.
Ÿ
Do not use an open flame to check for gas leaks.
Ÿ
Your grill must be leak tested outdoors in a well-
ventilated area, away from ignition sources such as
gas fired or electrical appliances. During the leak test,
keep your grill away from open flames or sparks.
Ÿ
Do not use household cleaning agents. Damage to
gas assembly components can result.
Use a clean paintbrush and a 50/50 mild soap and
water solution.
Brush soapy solution onto LP Gas tank in the areas
indicated by the arrows. See diagram.
If growing bubbles appear do not use or move the
LP Gas tank. Call an LP Gas Supplier or your Fire
Department.
WARNING
!
If growing bubbles appear do not use or move
the LP Gas tank. Contact an LP Gas Supplier
or your fire department!
WARNING
!
Before
using
this
instructions and perform all gas leak-check
procedures
even
pre-assembled by the retailer or manufacturer.
USE AND CARE INSTRUCTIONS
gas
appliance
read
if
the
product
LP Gas Model only:
Secure two 20lb LP Gas Tanks to Gas Grill
Turn your LP Gas Tank Valves clockwise to
the closed or OFF positon.
Hang your gas tanks on the top Tank Hooks.
The ring foot of the gas tanks will rest on the
Tank Holder.
Cylinders Installation Code
The handling, storage, and transporation of all sizes of gas
cylinders must be in accordance with ANSI/NFPA 58,
Storage and Handling of liquid Petroleum Gases, or the
CSA B149.1, Natural Gas and Propane Installation Code.
LP Gas Model only:
Connect Regulator with Hose to your LPG Tanks
Turn all Burner Valves to the OFF position.
Inspect the valve connection port and regulator
assembly for damage or debris. Remove any
debris. Never use damaged or plugged equip-
ment.
Connect the regulator assembly to the tank
valve and HAND TIGHTEN nut clockwise to a
full stop. DO NOT use a wrench to tighten
because it could damage the Quick Coupling
Nut and result in a hazardous condition.
Open the tank valve fully (counterclockwise) and
use a soapy water solution to check all
connections for leaks before attempting to light
your grill. See
If a leak is found, turn the tank valve off and
do not use your grill until the leak is repaired.
!
!
all
CAUTION: When the appliance is not in use the gas
was
12
"Checking for LP Gas Leaks".
Type 1 connection per
ANSI Z83.11-2006
must be turned off at the tanks.
Quick
Coupling Nut
Publicité
