Publicité
Les langues disponibles
Les langues disponibles
Install Ignitor Batteries
6
Unscrew Ignitor Cap from Control Panel.
Place supplied AA battery into the Ignitor
Slot with positive pole facing you.
Position the Cap and Spring over the AA
battery and tighten onto Control Panel.
Repeat to install the other AA battery
into the Ignitor Slot.
With the assistance of another person,
7
perform this Electrode Check before
proceeding.
This test will ensure that the Spark Electrode
Tips are properly positioned so your grill lights
easily and properly.
Be sure all Control Knobs are set to
"OFF" and open the Grill Lids.
Have your assistant stand behind to the
right of the grill and look toward the front
of the grill bowl. Never put your face
inside the Grill Head.
Press the Ignitor Cap. You should hear
a "clicking" sound. Your assistant should
see a blue spark within each Gas
Collector Box. If a spark is present the
Electrode Tips are properly positioned.
AA Battery
Ignitor Cap
If no spark is seen, the Spark Gap
needs to be adjusted as follows
•
If the gap between the Spark Elec-
trode Tip and Receiver is more than
3/16" use long nose pliers to gently
squeeze the Gas Collector Box to
narrow gap.
•
Recheck the Electrode again, if no
"clicking" sound is heard:
-
AA Battery is installed backwards.
-
Electric wires may be loose. Remove
the AA Battery and inspect the Ignitor
Junction Box found behind the Control
Panel and reconnect any loose wires.
Gas Collector Box
Spark Electrode Tip
-
+
Ignitor Slot
Spring
8
Install Cooking Components
Place the Savor Plates
above
Place Cooking Grids on bowl ledge.
Final Grill Assembly Step
When you have finished assembling your
grill be sure that all screws are tightened
for safe operation of your grill.
WARNING
!
Failure to read and follow the Use and Care
Instructions could result in a fire or explosion
that could cause serious bodily injury, death or
property damage.
Transporting or Storing your grill:
Lock grill Casters.
1.
Remove LP Gas tank and Grease Tray from your
2.
grill. Place Grease Tray on Lower Grease Tray
Bracket. See Fig.1.
Loosen 4 Latches on Grill Bowl and Cart. With an
3.
assistant, lift and position Grill Bowl on a cardboard
surface.
Fold the Cart Legs onto Cart Frame. See Fig.1.
4.
With an assistant, lift and position Grill Bowl onto
5.
the folded Cart. See Fig.1.
Lock 4 Latches on Grill Bowl and Cart. See Fig.2.
Be sure grill is secured tightly and covered when
6.
being transported.
Fig. 1
10
TM
on lower ledge
Burners.
Cooking Grids
Savor Plate
TM
!
Fig. 2
Publicité
