Schmidt SS 20.501 Mode D'emploi page 26

Flange mounting
•
Screw-tighten the flange to the duct wall via the three mounting bores.
•
Pull protective sleeve from sensor head 9.
•
Slide sensor along with sensor tube 7 into mounting flange 300227 (not
included in the delivery) and fasten it at the desired position by means
of the clamping screw.
Note: The mounting flange is not pressure-tight and may only be used in
pressure-free systems.
Abbreviations in the mounting drawings:
AL = stand-out length, SL = welding stud length, L = sensor length, L
of through bolt joint, MET = minimum immersion depth, D
Seite 26
= length
DGV
= tube outer diameter
A