Connections
■ Connecting a receiver
After connecting the antenna to a receiver, the antenna is powered, the audio from
microphone is transmitted to the receiver, and the audio output is enabled for the amplifiers
or speakers which are connected to the receiver.
1
Connect the antenna to the receiver via a LAN cable (page 16)
LAN cable
Wireless antenna
connectors 1 to 8
Receiver
The wireless receiver connectors on this antenna are the proprietary
Important
type. Do not connect any PoE devices (hubs or routers equipped with
Important
PoE). Doing so may cause malfunctions.
Use a straight (non-crossover) LAN cable for the connection. Using a
crossover LAN cable may cause the antenna to malfunction.
Use a LAN cable shorter than 200 m (656 ft).
When using multiple receivers, one of them must be set as a main receiver
in order to avoid interference. The reference antenna (the antenna plugged
into the [ANTENNA 1] connector on the back of the receiver) of the main
receiver must be powered at all times.
24
Antenna (side)
Wireless receiver connector
(inside the connector cover)
To AC120 V
60 Hz
electric outlet