Panasonic WX-SA250P Mode D'emploi page 19

⿟ Use the included cable tie to fix the cable onto the cable tie hook and partially pass
it through the routing groove on the rear of the antenna to avoid any excessive
pulling force on the cable during installation.
Cable tie
(included)
Cable tie hook
5
Install the antenna
A A ttach the antenna to the hooks on the fixing bracket. (Four places)
Grooves
B O pen the screw cover on the side of the antenna
and use the included mounting screw (M3x8 mm) to
secure the antenna to the fixing bracket.
⿟ Screw torque: 0.59 N•m to 0.69 N•m {6 kgf•cm to
7 kgf•cm}
C C lose the screw cover.
Important
⿟ Make sure that the mounting screws on the antenna are tightened
Important securely to keep the product from falling.
Not doing so may cause the antenna to fall.
⿟ Use a tool such as a torque screwdriver to tighten the screws to the
specified torque.
⿟ Use a magnetic screwdriver.
6
Checking the installation
After completing the installation, check that all components are securely fixed.
Check that there are no loose parts.
Hooks
Screw cover
Antenna mounting screw
(M3×8 mm) (included)
19