Installation; Installation Precautions - Panasonic WX-SA250P Mode D'emploi

Installation

■ Installation precautions

Warning
When installing the antenna, follow all official ordinances on electrical equipment
technical standards.
Do not power ON the equipment while installing it.
⿟ Make sure that all equipment is powered OFF while installing it. Also power OFF all
mixers, amplifiers, and other devices connected to the system. Failing to do so will result
in a loud noise coming out of the speakers and possibly damaging the system.
Installation
⿟ Do not use for extended periods of time in very hot or humid environments. The unit will
degrade more quickly and its expected lifespan will be reduced. Improve heat dissipation
near the installation place and make sure that the unit is not hit by direct sunlight.
Installation place
⿟ Install the unit within a range where it can communicate with the microphone.
⿟ When placed between the microphone and the antenna, devices such as displays or
projectors may cause interference and result in audio dropouts. Make sure that the
antenna has line-of-sight access to the microphone.
⿟ Place the antenna at as high a place as possible. Otherwise, people passing across the
low line-of-sight between the antenna and the microphone may cause interferences or
audio dropouts.
⿟ When installing the antenna on the ceiling, choose an unobstructed place distant from
pillars and beams (at least two or three meters).
14
⿟ Always ask a retailer to perform these operations.
⿟ Before installation, set the power switch on the devices
you want to connect to OFF. Carefully read the
"Precautions" chapter and follow all of its instructions. Also
refer to the manual of the devices you are connecting.
⿟ In order to avoid damages, properly install the antenna
to either the ceiling, a wall, or a microphone stand
according to the instructions in this manual.
Beam
At least
2 or 3 m
(6.6 or 9 ft)
At least
Pillar
2 or 3 m
(6.6 or 9 ft)