Detach Canopy And Seat Pad; Installation Without Base - Nuna pipa icon ECE R129/00 Mode D'emploi

Detach canopy and
seat pad
1 Detach the snaps to disassemble the canopy, press the
button in the canopy mount and pull the canopy bow out.
(33)
2 Pull the fastening pieces underneath the edge of the seat
(34)
out.
3 Press the red button to disengage the buckle
Remove the Infant Insert and crotch strap.
4 Detach the elastic band on the head support, and then
remove the head support.
5 Remove the seat pad from the adjustment button as shown
(35)
in.
6 Remove the seat pad from the Stroller release button as
(36)
shown in.
25
Installation
without base
1 DO NOT install this infant child restraint on vehicle seats with
2 This infant child restraint is suitable for vehicle seats with a
3 Place the infant child restraint onto the vehicle seat where
(23)
.
4 Slide diagonal belt into the rear guide.
5 Pull the vehicle shoulder belt to fasten the infant child
6 Level line on carrier must be level to the ground when the
(37)
Lap Belts.
3-point Retractor Safety Belt (without base) only.
you wish to put it. Pull the vehicle safety belt out and lock
it into the vehicle buckle, sliding the vehicle lap belt into the
side guides of the infant child restraint.
The infant child restraint can not be used if the vehicle
safety belt buckle (female buckle end) is too long to
anchor the infant child restraint securely.
restraint tightly and securely.
infant child restraint is installed.
Tension the vehicle safety belt as much as possible,
checking that it is not loose or twisted.
After installing the infant child restraint, always check
that the vehicle belts are routed correctly and securely
fastened into the vehicle buckle.
(38)
(39)
(39)
(40)
(41)
(43)
(42)
26