Care And Maintenance; Outer Shell; Face Shield And Sun Visor - SCHUBERTH R2 Manuel

G. CARE AND MAINTENANCE

1. OUTER SHELL

To clean the helmet shell, you can use water, soap or one of the commonly
available motorcycle shampoos, cleaners, polishes, plastic cleaners or cleaning
fluids. Using water and soap is usually sufficient. Make sure when using the
other cleaning materials that these do not come into contact with the face
shield, since they can cause damage to the visor and its coating.
Note:
Never use motor fuel, thinners or solvents to clean the helmet. These
substances can cause serious damage to the helmet with no external
signs. The full safety function of the helmet can then no longer be
guaranteed.
2. FACE SHIELD
OUTER SURFACE OF THE FACE SHIELD
Use a soft cloth and a mild soap solution (< 20 °C) to remove dirt from the
outside of the face shield. To dry the face shield, use a lint-free cloth and apply
gentle pressure.
ANTI-FOG LENS
The inside surface of the face shield must only be cleaned with a soft cloth,
which may be slightly dampened if required (we recommend a mocrofibre cloth).
Do not use any cleaning agents.
Note:
Only use tepid water (< 20 °C) for cleaning. Never on any account clean
the face shield or sun visor with petrol, solvent, a window or glass cleaner
or other cleaning agents containing alcohol.
Note:
The face shield should not be soaked in water even if it is very dirty on
the outside, as this will severely reduce the surface hardness and thus the
durability of the anti-fog/anti-scratch coating.
64