SCHUBERTH R2 Manuel page 52

C. THE HELMET
ANTI-FOG LENS
Fitting
1. Lay the anti-fog lens in the face shield in such
a way that one side of it is already slotted into
the locking pin.
2. Now grasp the other side of the antifog lens by
its upper and lower transverse edges and use
your index finger to gently press the end of the
visor into a slight "S" shape. Now you can easily
guide the slot over the locking pin and release
the anti-fog lens into place.
3. The anti-fog lens should now be positioned in
the face shield with its lower edge parallel to
the lower edge of the face shield. If you need
to change the positioning of the anti-fog lens,
use the balls of your thumbs to gently bend the
face shield apart until the inner visor can be
adjusted as required.
4. Check all round the visor to make sure that the silicone seal fits tightly and
evenly against the face shield. Only if this is the case will the anti-misting
properties function properly.
5. If you have not already done so, please remove the yellow protective film.
50