Publicité
N
x 12
FIG. 8
TO SQUARE THE UNIT:
Place the unit face-down on a clean, protected surface. Measure from the top left corner to the bottom
8.
right corner (
should be equal. If the line (
measurements are equal. If the line (
See Figure 8.
Attach the Upper Back Panel (F) to the unit using 12 #6x5/8" Philtruss Screws (N) through the
predrilled holes in the back. Make sure the top edge of the back is flush with the top edge of the top
shelf and centered from side to side. See Figure 8.
O
N
x 18
Fig. 9
9. Position the Lower Back Panel (G) with the top edge against the bottom edge of the Upper Back
Panel (F) and centered side to side. Attach the back panel to the unit using #6 x 5/8" Philtruss
Screws (N) through the predrilled holes in the back. See Figure 9.
Add six #6 x 5/8" Philtruss Screws (N) with six Washers (O) between the upper and lower back.
Align the screws with those at the top and bottom of the unit. See Figure 9.
N
N
N
N
N N
F
N
N
1
Ba
) and from the bottom left corner to the top right corner (
) is longer, tap the bottom of the Left Side Panel (Aa) until the
N
O
x6
N N
N
N
3
) is longer, tap the bottom of the Right Side Panels (Ba).
N
N O
O
N
F
O
N
O
N
O
N
N
O
N
N
N
Aa
4
). The measurements
N
N
N
N
G
N
N
2
N
N
Page 7 — 496Wa — 08/13
Publicité
