Configuration Using A Web Browser - THOMSON DSC-353G Mode D'emploi

d - CONFigurATiON ANd uSE
1 Tick "Yes" to activate motion detection then
click "Save" to display the area grid on the
image.
Sensitivity: on "élevée [high]", the smallest
2
movement on the screen triggers an alert.
on "minimum", only the biggest objects will
trigger an alert (for example: a human being,
but not a dead leaf in the camera's fi eld of
vision). Adjust to suit the camera's fi eld of
vision and the desired objective.
Trigger interval: pause between alerts if
3
motion is detected over an extended period
Detection area: The camera feed appears
4
behind a grid. If motion is detected in a
red box, an alert is triggered. If motion is
detected in a blank box, no alert is given.
Click on boxes to activate them (red) or
deactivate them (blank), for example,
so as not to focus on a window and to
prevent anything on the outside from being
unnecessarily triggered.
IMPORTANT: When you have fi nished confi guration,
do not forget to click "Save" at the top of the screen
to save everything you have entered.
This completes the confi guration. From now on, any
motion detected by the camera in the zones and
at the times you have specifi ed will trigger an email
alert.
16
en
4
1 2 3
720P HD WiFi iP camera
3 - CONFIGURATION USING A WEB
BROWSER
Warning: frequent policy changes made by the
main web browser developers as well as the number
of possible confi gurations and versions can make
it tricky to confi gure your camera. If possible, it is
preferable to use a smartphone, tablet or dedicated
software.
• Insert the installation CD provided into a reader
and run the IP Camera Search Tool program: and run the IP Camera Search Tool program:
• This will detect your camera on the network
and show its IP address.
• Double-click on its name to open the camera
confi guration in your web browser.
Your browser will need an additional module to
display the image from your camera correctly and will
ask you if you want to install it. Accept the request to
allow your browser to display the image:
Note: Depending on which browser you are using,
the procedure may differ but the principle remains
the same: you must permanently allow the module
to run if you want your camera to work properly in
your browser.