IMER SPIN 15 Manuel D'utilisation Et Entretien page 13

The hazardous points on the IMER mixer are protected by means
kept in perfect condition. For example, this includes the electric
motor cooling fan guard and the hopper grid (ref. 10) to prevent
contact with the auger.
Also, release of the mixing chamber, shuts down all rotary parts
- CAUTION! Before moving the mixer, always detach
the power plug.
Before moving the mixer, disconnect the water supply hose.
Only a minimal amount of the material should be in the hopper
when handling.
-CAUTION! Before lifting the mixer, always check that all ma-
and no objects have been left on the surface
- CAUTION! Lift with care to avoid hazardous oscillations
3 to lift the machine
IMER INTERNATIONAL S.p.A.
SPIN 15
9. INSTALLATION
ronment where it does not constitute an obstruction either during
use or cleaning at the end of the work shift.
the material outlet.
10. CONNECTIONS
current overload (e.g. by means of fuses or a thermal magnetic
cut-out) and against dispersion current to earth (e.g. with a dif-
ferential circuit breaker). The electric cable wire size must take
into account the operating currents and length of the line to avoid
excessive voltage drops.
Avoid use of extension leads wound on drums. The power cable
must be suitable for frequent movements and with an abrasion
resistant sheath
(e.g. type H07RN-F).
Before connecting the mixer to the electrical mains, ensure that all
particular that the hopper grid is secured in place, that the exten-
sion in good condition and that the plugs and sockets are not wet.
Connect the mixer socket on the electrical panel to the mains
13
- Ensure that the power supply voltage, mains frequency
-