Accessory Compartment; Storing The Machine; Troubleshooting - Magicvac P0608ED Instructions Sur Le Fonctionnement

In the upper part of the machine there is a convenient Accessory Compartment (15) where you can
keep the Canister Tube (16) (fig. X3) and the Bag Cutter, manual MAGIC Cutter (where applicable)
(fig. X4).
fig. X1
When you are not using the machine, you can place it in a vertical position to reduce space.
Proceed as follows:
a) Insert the Power Cable (17) in the Cable Compartment (18) on the back of the machine (fig. W1).
b) Close the machine by rotating the Handles (1) to the STORAGE position (fig. W2 and W3).
ATTENTION: do not turn the Handles (1) to the START position because complete closure of the
machine when it is inactive for a long period of time could damage the Airtight Seal (7) causing a
leak in the Vacuum Chamber (8) and subsequent failure of the machine to work properly.
c) Place the machine in a vertical position far from heat sources (fig. W4).
fig. W1
17
• Make sure the power cable on the MAGIC VAC
MAGIC VAC ® does not
work
• Make sure the power cable and/or plug is not defective. If so, do not use the
• Check that the piece of cut roll is correctly positioned as described in the
MAGIC VAC ® does not
perform the first seal on
the piece of cut roll.
MAGIC VAC ® does not
• In order to correctly seal the bags, the open end must be entirely inside the Vacuum
completely vacuum-
pack the bags

ACCESSORY COMPARTMENT

fig. X2

STORING THE MACHINE

fig. W3
fig. W2
18

TROUBLESHOOTING

and in the electrical outlet. Check the electrical outlet by trying another device in
the same outlet.
machine.
paragraph: "5 - Making bags from MAGIC VAC
integrity of the Sealing Gasket
Chamber (8). Check the correct position through the Lit WINDOW (3).
39
fig. X4
fig. X3
fig. W4
® is fully inserted in the machine
®
rolls". Check the position and