Starting Engine - Yamaha Motor F8 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Arrow
2. Primer pump
EMU27495

Starting engine

EWM01601
WARNING
Before starting the engine, make sure that
the boat is tightly moored and that you can
steer clear of any obstructions. Be sure
there are no swimmers in the water near
you.
EMU34815
Manual start models (tiller control)
EWM01842
WARNING
 Failure to attach the engine shut-off
cord could result in a runaway boat if
operator is ejected. Attach the engine
shut-off cord to a secure place on your
clothing, or your arm or leg while oper-
ating. Do not attach the cord to clothing
that could tear loose. Do not route the
cord where it could become entangled,
preventing it from functioning.
 Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power, the
boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
Starting procedure (cold engine)
1.
Place the gear shift lever in neutral.
TIP:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2.
Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
3.
Place the throttle grip in the "
(start) position.
Operation
N
ZMU07884
ZMU07885
"
41

Publicité

Chapitres

Table des Matières
loading

Table des Matières