Remington Durablade Pro MB070 Mode D'emploi page 5

TRIMMING AND EDGING
1. Fit the detail blade.
2. Hold the groomer with the back side of the blade facing you with no combs attached.
3. Start with the blades resting lightly against your skin, use motions towards edge of
beard line to trim to desired locations in facial area.
4. Shape as desired.
TRIMMING WITH SHAVING GEL
Follow the same instructions as dry shaving if using shaving gel.
Caution: After use with shaving gel, please rinse the blade under warm water to clean away
any excess gel and debris.
CARE OR YOUR GROOMER
To ensure long lasting performance of the groomer, clean after each use.
The easiest and most hygienic way to clean the groomer is by rinsing the head under the tap
after use while the blades are running.
To keep the unit in optimal condition we recommend re-oiling the blades after cleaning.
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
BATTERY REMOVAL
The battery must be removed from the appliance before it is scrapped.
The appliance must be disconnected from the supply mains when removing the battery.
1. Ensure the trimmer is discharged of all power.
2. Remove the comb attachment.
3. Detach the blade head.
4. Pry off the bottom gap below the grips.
5. Press in exposed tabs and pull internal frame out.
6. Disconnect the battery from the circuit board and internal frame.
7. The battery is to be disposed of safely.
RECYCLING
W
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate official recycling/
collection point.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
5