Cleaning & Maintenance; Descaling - Inventum KZ610 Mode D'emploi

Attention: This appliance is fitted with an anti-drip system. This allows you to remove the coffee jug so that you can pour yourself a
cup of coffee while it is still brewing. Quickly replace the coffee jug to prevent the filter holder from overflowing.
SWITCHING OFF
Always switch off the appliance after use, press the on-/off button.
The coffeemaker will keep the coffee warm for 35 minutes. After the 35 minutes the coffeemaker will automatically switch off.
In this respect, this appliance complies with the EU's energy consumption regulations.
Don't forget to throw away the paper coffeefilter. Open the lid of the filter and remove the filterholder. When you use a permanent
filter, empty this, rinse it and you can use it again.
5
cleaning & maintenance
Regular cleaning will prolong the life of your appliance and will guarantee optimal brewing results.
Before cleaning:
• Check if the appliance is switched off and the plug is unplugged.
• Clean the outside of the appliance regularly with only a damp cloth or sponge and dry it with a dry cloth. Never use any abrasives.
Never place the appliance in water or under running water.
• Clean the glass jug, the permanent filter and the filterholder with warm water and some washing-up liquid. Dry the parts thoroughly
before you place them back. Never wash the glass jug, the permanent filter and filterholder in the dishwasher.
6

descaling

Regular descaling will prolong the life of your appliance and will guarantee optimal brewing results. The coffeemaker must be descaled
at regular intervals: every 40 cycles for very hard water (about once a month) and every 80 cycles for soft water (about once every 2
months). But more frequent descaling may be necessary if you notice: an increase in noise when boiling or if brewing takes longer. You
can use either a sachet of descaler or cleaining vinegar.
When you use a descaler for coffeemakers, follow the instructions on the package.
When you are using cleaning vinegar do as follows:
1. Switch off the appliance, unplug it and let it cool down. Remove all the separate parts ( jug and filterholder).
2. To remove excess water turn the machine upside down over the sink.
3. Fill the waterreservoir up to halve with cold vinegar and add fresh, cold water to the maximum level. Place the jug on the
warmingplate and place the filterholder with an empty paper filter on the holder.
4. Switch the appliance on.
5. Allow the equivalent of halve the amount to run through into the coffee jug. Then stop the coffeemaker. Leave the remaining
mixture in the coffeemaker to work for 15 minutes. Restart the coffeemaker to finish the runthrough.
6. Rinse the coffeemaker by running it 2 or 3 times with fresh water (full water tank and without coffee).
Attention! If you haven't used the coffeemachine for a while, for instance if you have been away on a holiday, you should remove all
the separate parts for cleaning and rinse the coffeemachine with fresh water. Place the cleaned parts in the machine. This prevents
an additional taste.
11
English •