Fein WSG8-115 Mode D'emploi page 23

OBJ_BUCH-0000000131-002.book Page 23 Thursday, January 23, 2014 1:23 PM
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching on and off (figure 9).
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
The self-start lock prevents the angle grinder
(see Table) from automatically restarting
again, even after a brief interruption of the
power supply, e. g., from a pulled power plug.
Switching on:
Push the switch toward the front (I).
Switching off:
Push the switch toward the rear ().
Angle grinders with electronics (see Table)
are equipped with overload and blocking pro-
tection. In case of overload or blocking of the
application tool, the power supply is inter-
rupted. in this case, switch the power tool off,
remove it from the workpiece and check the
application tool. Afterwards, switch the
power tool on again.
WSG12-125P WSG15-150P
WSG15-125P WSG15-70Inox
WSG15-125PS
Fig. 9
On/Off switch
en
23