Fein WSG8-115 Mode D'emploi page 22

OBJ_BUCH-0000000131-002.book Page 22 Thursday, January 23, 2014 1:23 PM
en
22
Adjustments.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
Adjusting the wheel guard (figure 7).
Release clamping lever.
Turn the wheel guard to the requested work-
ing position, then clamp the wheel guard with
the clamping lever.
Allow the clamping lever to engage.
Turning the gear head (figure 8).
The gear head can be turned by 180° with
respect to the housing. This allows you to set
the On/Off switch to a more favorable han-
dling position for special jobs.
Unscrew the four screws.
Carefully turn the gear head to the new posi-
tion without removing it from the housing.
Mount and tighten the four screws again.
Clamping lever
Gear head
2.
180°
4x
1.
3.
m
0 m