Finish Cutting Process; Cleaning; Maintenance; Tools And Accessories - Baier Elektrowerkzeuge BMF 501 Mode D'emploi

5.5

Finish cutting process

DANGER
Risk of injury due to an uncontrolled recoil of the
wall chaser, caused by canting of the wall chaser in
the cut chase.
Î Always wait for the cutter to stop completely
before removing the wall chaser from the cut
chase.
•
7 The wall chaser switches off as soon as the
pressure on the control handle (4) in the direc-
tion of cutting is reduced.
•
Do not remove the wall chaser from the chase
and put it down until the cutter has completely
stopped rotating.
6

cleaning

DANGER
Risk of fatal injuries due to electric shock.
Î Disconnect the mains plug before carrying out
any work on the wall chaser.
The machine must be cleaned after each cutting
work session.
•
Clean the machine carefully.
•
Ensure handles are dry and free from grease.
7

Maintenance

DANGER
Risk of fatal injuries due to electric shock.
Î Disconnect the mains plug before carrying out
any work on the wall chaser.
The wall chaser must be serviced at least once a
year. Further, servicing will be necessary depending
on the wear of the carbon brushes.
Only servicing and repair firms authorised by
Maschinenfabrik OTTO BAIER GmbH may car-
ry out maintenance of the machine. Also ensure
that original BAIER spare parts and original BAIER
accessories only are used.
8

Tools and Accessories

•
BAIER special dust extractor
(Id. No. see BAIER Catalogue)
•
Aluminium discs (10) (Id. No. 3657)
•
Dust extractor cover (Id. No. 47084)
BAIER cutters ID. No.
Euro cutter 20 55657
Euro cutter 25 54650
Cutter 4 30866
Cutter 318 31062
Cutter 67 12088
Cutter 67 for
sand-lime
12096
(calcium silicate)
brick
9

Disposal

Recycle the machine and its packaging
in an environmentally friendly way in
accordance with the provisions applicable
in your country.
10

Scope of Supply

Please refer to the enclosed delivery note for the
individual scope of supply of a customer- specific
order.
Please refer to the table below for the scope of
supply of basic models. Please contact your dealer
if parts are missing or damaged.
Wall chaser
Basic selection ld. No.
59568
BMF 501
67207
x included in scope of supply
chase chase
depth width
[mm] [mm]
23 – 35 20
25 – 38 25
23 – 35 13
23 – 35 18
23 – 35 30
23 – 35 30
Dust Euro
extraction cutter 25
x
x x
| 29 |