marklin 44 Serie Mode D'emploi page 13

Setting Locomotive Parameters with the Control Unit
1. Requirement: Setup as in diagram 1. Only the locomotive to be
changed can be on the track.
2. Press the "Stop" and "Go" at the same time until "99" blinks in the
display.
3. Press the "Stop" button.
4. Enter the address „80".
5. Hold the speed control knob in the reverse direction position con-
stantly. Press the "Go" button while you do this. The headlight on
the locomotive will blink. If no, repeat starting at Step 2.
6. Enter the register number for the parameter to be changed
(=> List 1).
7. Activate the direction reversal.
8. Enter new value (=> List 1).
9. Activate the direction reversal.
10. End the procedure by pressing the "Stop"
button. Now press the "Go" button.
Operation with the Mobile Station/CentralStation
• Set the locomotive on the track. The locomotive automatically
registers itself in the locomotive list.
• During operation:
Speed indicator blinks => no connection to the locomotive.
• Taking the locomotive out of the locomotive list:
1. Remove the locomotive from the track.
2. Delete the locomotive entry.
• It is not necessary to change the address.
• Changing Locomotive Parameters with the Mobile Station: Please
note the information in the instructions for the Mobile Station /
Central Station.
Diagramm 1
80
1
2

01 01
2
1


List 1: parameter
Address
Acceleration delay
Braking delay
Maximum speed
Reset to series values
Volume
Betrieb • Operation • Fonctionnement • Exploitatie
13
99 1
1

80
1
1

10
1
2
1

Register Number
01
03
04
05
08
63

10
1

Value
01 - 79
01 - 63
01 - 63
01 - 63
08
01 - 63