7�2�1 Adjustable Parameters - Autosen IO-Link AL007 Notice D'utilisation

All manuals and user guides at all-guides.com
7.2.1 Adjustable parameters
Among others, the following parameters can be set via IO-Link�
A table of all adjustable parameters can be found at
www�autosen�com
Parameters for the receiver (AL008)
Parameter Values
name
SSC1 Param� 1 ��� 100
SP1
Teach SP1 TP1
Teach SP1 TP2
TI Result�State - Idle
- SP1
Success
- Wait for
command
- Busy
- Error
- Custom
SSC1 Config� High
Logic active
Low active
SSC1 switch-on 0 ��� 2
delay
SSC1 switch-off 0 ��� 2
delay
Excess gain 0 ��� 5
Number of 0 ��� 65535 Number of switching operations (power up)
power cycles
Description
Setting switch point in step increment "1"�
After a teach process the resulting value is
displayed�
1� Part of the teach sequence to set switch
point SP1 by teach on object� Both parts of
the teach sequence for TP1 and TP2 (TP =
teach point) have to be carried out�
2� Part of the teach sequence to set switch
point SP1 by teach without object� The
second part of the teach sequence has to
be carried out after the first part�
Teach-in status; after successful teach the
value "SP1 Success" is displayed�
Switch point logic, status for detected object
(High: light-on mode / normally open, Low:
dark-on mode / normally closed)
Start-up delay; step increment 0�1 s
Switch-off delay; step increment 0�1 s
Excess gain at receiver�
of the sensor
Standard
setting
100
UK
N� A�
N� A�
N� A�
→
Data
sheet value
"Output
function"
0
0
N� A�
N� A�
21