GreenWorks ELITE ST-140-T Manuel Du Propriétaire page 19

OPERATION
REPLACING THE LINE (See Figure 10.)
1. Press the tabs simultaneously on the side of the trimmer head and remove cover and spool.
2. Remove any remaining line.
3. Clean dirt and debris from all parts. Replace spool if it is worn or damaged.
4. Replace with a pre-wound spool, or replace line using 25 feet (8 meters) of 0.080 inch (2.0
mm) diameter line.
W A R N I N G
Never use wire, rope, string, etc., which can break off and become a dangerous projectile.
5. When installing new line on an existing spool, hold the spool as shown.
6. Bend the line at the midpoint and insert the bend into the slot in the center rim of the spool.
Ensure line snaps into position in the slot.
Tab
Cover
Spool
Slot
19
Tab
Fig. 10.1
Fig.10.2