ASSEMBLY
2.
Attach the auxiliary handle (2) and lower clamp (3) on the shaft.
3.
Adjust handle up or down, if necessary, to desired operating position.
4.
Insert and tighten the two screws so that the handle cannot be rotated on the shaft.
LINE TRIMMING CUT-OFF BLADE (See Figure 6.)
The trimmer is equipped with a line trimming cut-off blade on the guard. Replace the string when
trimming efficiency diminishes. This will maintain best performance.
1
2
Cut-off Blade
14
14
Fig.5.1
3
Fig.5.2
Fig.6