Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.
Turn the sleeve clockwise and open chuck's jaws
completely.
5.
Turn feed handles anti-clockwise and force chuck
against the table until the chuck is secure.
ADJUSTING THE TABLE SQUARE TO HEAD
NOTE: Use a precise right angle square (not included)
1.
Insert a straight ground stell ord or a straight drill
bit (not included) approximately 8 cm long into the
chuck and tighten.
2.
With the table raised at a working height and
locked on column, place the combination square
flat on the table beside the rod.
3.
If an adjustment is necessary, loosen the set
screw under bevel lock with 24mm flat wrench.
These adjustments are located under the table.
4.
Align the table square to the bit by rotating the
table until the square and the bit are in line.
5.
Retighten the table bevel lock.
6.
Retighten the set screw.
BEVEL SCALE
NOTE: The bevel scale has been included to provide a
quick method for beveling the table to aproximate
angles. If precise accuracy is necessary, a square or
another precision measuring tool should be used to
position the table.
To use the bevel scale proceed as follows:
1.
Loosen set screw and table bevel lock (see step 3
above).
2.
Move the table so that the desired angle or bevel
scale is straight across from zero line on table
support.
3.
Retighten table bevel lock and set screw.
Quill
Arbor
Chuck
Table
Set
bevel
screw
lock
Vite di
Bloccaggio
fermo
inclinazione
piano
Pointer
Scale
Puntatore
Scala graduata
Table
Piano
Table
Piano
32
Publicité
Chapitres
Table des Matières
