Fox F12-943A Manuel D'instructions page 30

INSTALLING THE TABLE
1. Loosen the support lock and raise the table
support by turning the table crank clockwise until
the support is at a working height level. Tighten
support lock.
2. Remove the protective covering from the table.
Place the table in the table support and tighten the
table lock (located under the table) by hand.
NOTE: If table won't fit into the table support
easily, try to open the table support with a falt
blade screw driver.
INSTALLING THE HEAD
CAUTION: Head assembly weighs about 25 kg.
Carefully lift head in two people.
1. Remove protective bag from head assembly.
Carefully lift head above column tube and slide it
onto column making sure that the head slides
down over the column as far as possible. Align the
head with the table and the base.
2. Locate two D 10 mm x 12 mm long set screws
(see illustration) in loose parts bag.
3. Install a set screw in each hole (as indicated) on
the right side of the head, and using a 5mm hex
"L" wrench, tighten the two head lock set screws.
Support
lock
Table
support
Column
Table lock
Head
Table crank
Rack
Table
support
Table
Column
Head lock set
screws
Head
30