Polarizing Set (Optional) - Optika Italy B-60 Serie Manuel D'utilisation

7.4 Assembling the microscope
The microscope comes already assembled from the
factory. No assembling procedure is requested.
1. Open the battery compartment placed in the low-
er part of the frame. (Fig. 1)
2. Insert batteries, respecting polarity.
3. Close the battery compartment.
4. Plug the jack of the power supply into the socket
① in the back side of the microscope. (Fig. 2)
7.5

Polarizing set (optional)

1. Place the polarizer on the light exit lens ② at the
base of the microscope. (Fig. 3)
2. Using a flat screwdriver (not provided) loosen the
fixing screws on the two sides of the microscope
③. (Fig. 4)
①
Page 8
F F ig. 1 ig. 1
F F ig. 2 ig. 2
②
F ig. 3 F ig. 3
③
F F ig. 4 ig. 4
F ig. 4 F ig. 4