Changing The Light Bulb - AEG SANTO 70340-8 KA Mode D'emploi

Malfunction
Unusual noises.
The compressor does not start
immediately after changing
the temperature setting.
Water on the floor or on
storage shelves.

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the light bulb,
switch off the appliance and unplug it, or pull the fuse or the circuit breaker.
Light bulb data: 220-240 V
1. To switch off the appliance, push the
button ON/OFF (A).
2. Unplug the mains plug.
3. To change the light bulb press on the
rear hook and at the same time slide
the cover in the direction indicated
by the arrow.
4. Change the defective light bulb with
one of the some power (the
maximum power is shown on the
light diffuser).
5. Refit the light bulb cover.
6. Put the refrigerator back into
operation.
34
Possible Cause
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
Remedy
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts after a
period of time.
See the "Cleaning and Care"
section.