Radio Receiver; Receiver Technical Specifications; Radio Channel Functionality; Antenna Installation - O&O DEC-SC Manuel D'installation Et D'utilisation

- Max. n° of radio transmitters that can be memorized:
- Frequency:
- Code by means of:
- N° of combinations:
Use an antenna tuned to 433MHz. Connect the
tuned antenna to the antenna terminals using
RG58 coaxial cable .
In the case of standard installations where no advanced functions are required, it is possible to proceed to
manual storage of the transmitters, making reference to programming table A and to the example for basic
programming.
1) If you wish the transmitter to activate output 1, press pushbutton PR1, otherwise if you wish the
transmitter to activate output 2, press pushbutton PR2.
2) When LED DL1 starts blinking, press hidden key on the transmitter, LED DL1 will remain continuously lit.
3) Press the key of the transmitter to be memorized, LED DL1 will flash quickly to indicate that it has been
memorized successfully. Flashing as normal will then be resumed.
4) To memorize another transmitter, repeat steps 2) and 3).
5) To exit memorizing mode, wait for the LED to go off completely or press the key of a remote control that
has just been memorized.
IMPORTANT NOTE: ATTACH THE ADHESIVE KEY LABEL TO THE FIRST MEMORISED TRANSMITTER
(MASTER).
In the case of manual programming, the first transmitter assigns the key code to the receiver; this code is
necessary in order to carry out subsequent cloning of the radio transmitters.
This mode is used to copy the keys of a transmitter already stored in the receiver memory, without acces-
sing the receiver.
The first transmitter is to be memorised in manual mode (see paragraph 8.4).
a) Press hidden key on the transmitter already memorised.
b) Press key T on the transmitter already memorised, which is also to be attributed to the new transmitter.
c) Within 10 s., press hidden key on the new transmitter to be memorised.
d) Press key T to be attributed to the new transmitter.
e) To memorise another transmitter, repeat the procedure from step (c) within a maximum time of 10
seconds, otherwise the receiver exits the programming mode.
f ) To copy another key, repeat from step (a), having waited for the receiver to exit the programming mode
(or after disconnecting the receiver from the power supply).
It is recommended to make an installation which has all the accessories necessary to ensure operation according to current provisions,
always using genuine O&O devices.
This equipment must be installed and used in strict compliance with the manufacturer's instructions. The manufacturer cannot be held
responsible for any damage deriving from improper or unreasonable use.
O&O srl disclaims all liability for any inaccuracies contained in this booklet and reserves the right to make changes at any time without
any prior notice whatsoever.

8. RADIO RECEIVER

8.1 RECEIVER TECHNICAL SPECIFICATIONS

8.2 RADIO CHANNEL FUNCTIONALITY

Channel 1: Start command
Channel 2: AP.PED command (Pedestrian Opening)

8.3 ANTENNA INSTALLATION

8.4 MANUAL PROGRAMMING

8.5 SELF-LEARNING MODE PROGRAMMING

9. ATTENTION

64
433.92MHz
Rolling-code algorithm
4 billion
antenna cable RG58
- 12 -
Hidden key
Hidden key