Reversing Your Oem Blades - DK2 POWER OPC503 Guide De Montage

SAFETY & OPERATION
HOW TO REVERSE YOUR CHIPPER BLADES
1. Turn your engine key off, remove the key and unplug the spark plug on the engine.
2. Remove the rear cover on the chipper housing.
3. Before removing the bolts that mount the blades, place paper towels in the area opening
under the blade and the drum housing. This will help to catch bolts from dropping into the
bottom of the drum housing.
4. Remove the first bolt.
5. NOTE: Before removing the last bolt be sure to support the blade from sliding down into
the drum.
Remove the blade, reverse it to the new sharp edge and re-install it. Use only DK2 POWER
6.
OEM blades.
7. Use Loctite on the bolt threads when replacing bolts.
Remove the feed chute to access additional blades.
8.

REVERSING YOUR OEM BLADES

2 4
8
5
8
v.210817 | 11