Functional Description; Product Features; Spindle Lock - eXact PipeCut 280E Conseils D'emploi

Safety, Operation
Extension cords
An extension cord must have adequate wire size
(AWG or American Wire Gauge) for safety. The
smaller the gauge number of the wire, the greater
the capacity of the cable, that is 16 gauge has more
capacity than 18 gauge. An undersized cord will
cause a drop in line voltage resulting in loss of
power and overheating. When using more than one
extension to make up the total length, be sure each
individual extension contains at least the minimum
wire size. The following table shows the correct size
to use depending on cord length and nameplate
ampere rating. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier
the cord.(see page 4).
Motor
Be sure your power supply agrees with nameplate
marking. As little as 10% lower voltage can cause
loss of power and can result in overheating. All
Exact Tools products are factory-tested; if this tool
does not operate, check the power supply.
WARNING: Accessories must be rated
for at least the speed recommended on
the tool warning label. Accessories running over
rated speed can fly apart and cause injury.
Accessory ratings must always be above tool speed
as shown on tool nameplate.
DANGER: Avoid contact with the blade
teeth to prevent personal injury

Functional Description

Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Intended Use
PipeCut 280E /360E:
The PipeCut 280E/360E pipe saw is intended for
use as a pipe fitter's tool at the installation site. The
PipeCut 280E/360E pipe saw can only be used to
cut round pipes, with a diameter of 280E:1.6"-11"(40
mm – 280 mm) or 360E: 3"-14"(75 mm – 360 mm)
and a maximum wall thickness of
steel and other ferrous and non-ferrous materials
and 1.5" (38 mm) with plastics. The PipeCut
280E/360E pipe saw can be used to cut all normal
pipe materials, such as steel, stainless steel, cast
iron, copper, aluminium and plastic. PipeCut
280E/360E pipe saw is intended for short, intermittent
use. The machine may be loaded for 2,5 minutes
during a 10-minute period (S3 25 %). PipeCut
280E/360E pipe saw is not intended for use in
industrial production. Use pipe holders to support
pipe.
0.4" (10 mm) with
10

Product Features

While reading the operating instructions, unfold the
graphics page for the machine and leave it open.
This page is folded under the cover of this manual
(page 3). The following numbering of the product
features refers to this illustration.
Figure A
1. UNLOCK button
2. Power switch
3. Power-switch locking lever
4. Blade-guard cover
5. Overload indicator light
6. Moving blade-guard
7. Edge of moving blade-guard
8. Adjustable wheel
9. Operating handle
10. Chip removal lever
11. Chip removal nozzle
12. Blade-guard screw
13. Spindle-lock button
14. Rating plate
15. Motor unit
16. Speed control
17. Gripper unit
18. Gripper safety
19. Gripper adjustment handle
e n g l i s h