Installing And Changing The Saw Blade - eXact PipeCut 280E Conseils D'emploi

Operation, Maintenance
The pipe saw gripper has one adjustable wheel (Fig
A/9) which be used for improving the quality of the
cut and for reducing the misalignment. The
adjustment applies only to the actual pipe size and
material, and the wheel may have to be readjusted
as the blade is worn.To adjust the wheel, loosen the
locking screw (Fig N/1) and turn the wheel centre
clockwise or counter clockwise to the desired position
(Fig N/2), and lock the wheel again (Fig N/3). If the
blade has wandered too much to the left, adjust
wheel centre clockwise (- sign). If the misalignment
is to the right, adjust counter clockwise (+ sign). The
extent of the adjustment depends on the actual
misalignment. Remember to lubricate the adjusting
wheel at regular intervals.
Installing and changing the
saw blade
WARNING: To reduce the risk of injury, turn unit
off and disconnect it from power source
before installing and removing
accessories, before adjusting or when
making repairs. An accidental start-up can cause
injury.
Remove the power plug from the socket. Check that
the motor unit is locked in the upper position.
Remove the blade guard cover (Fig. O/1) by opening
the two screws (Fig. O/2). Press the spindle-lock
button (Fig. A/11) and simultaneously rotate the
blade by hand until the spindle-lock button drops a
further distance of about 0,2". Now the rotation of
the blade is prevented. Use the blade key to open
the blade attachment bolt. Remove the securing bolt
(Fig. O/3), the washer (Fig. O/4), the blade flange
disc (Fig. O/5), and the blade (Fig. O/6).
Before installing a new blade, check that both blade
flange discs are clean. Place a new or sharpened
blade on the back flange disc (Fig. O/7), so that the
marked side of the blade is facing outwards and the
arrows on the blade are facing in the same direction
as the rotation direction markings on the inside of
the blade case. Ensure that the new blade goes
right to the bottom in the back flange disc. Put the
blade flange disc, the washer, and the securing bolt
back in place. Press the spindle lock button and
tighten the blade securing bolt. Put the blade guard
cover back in place and tighten the bolts.
Fig N
Fig O
Fig P
4
14
e n g l i s h
1
3
2