Functional Description; Product Features - eXact PipeCut+Bevel 170E Conseils D'emploi

Safety, Operation
Extension cords
An extension cord must have adequate wire size
(AWG or American Wire Gauge) for safety. The
smaller the gauge number of the wire, the greater
the capacity of the cable, that is 16 gauge has more
capacity than 18 gauge. An undersized cord will
cause a drop in line voltage resulting in loss of
power and overheating. When using more than one
extension to make up the total length, be sure each
individual extension contains at least the minimum
wire size. The following table shows the correct size
to use depending on cord length and nameplate
ampere rating. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier
the cord.(see page 4).
Motor
Be sure your power supply agrees with nameplate
marking. As little as 10% lower voltage can cause
loss of power and can result in overheating. All
Exact Tools products are factory-tested; if this tool
does not operate, check the power supply.
WARNING: Accessories must be rated
for at least the speed recommended on
the tool warning label. Accessories running over
rated speed can fly apart and cause injury.
Accessory ratings must always be above tool speed
as shown on tool nameplate.
DANGER: Avoid contact with the blade
teeth to prevent personal injury
NOTE: When using a generator as power
source it has to be TRUE SINE WAVE
style INVERTER GENERATOR with
minimum power of 2000W / 2.5 kVA.

Functional Description

Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Intended Use
PipeCut+Bevel 170E:
The PipeCut+Bevel 170E pipe saw is intended for
use as a pipe fitter's tool at the installation site. The
PipeCut+Bevel 170E pipe saw can only be used to
cut or to cut and bevel round pipes, which are made
of cast iron or plastics with a diameter of 15-170
mm (0,6"-6") and wall thickness 8 mm (0,31") with
cast iron and 14 mm (0,55") with plastics. The
PipeCut+Bevel 170E pipe saw can be used only to
cut or to cut and bevel cast iron and certain plastic
materials.The PipeCut+Bevel 170E pipe saw is
intended for short, intermittent use. The machine
may be loaded for 2,5 minutes during a 10-minute
period (S3 25 %). The PipeCut+Bevel 170E pipe
saw is not intended for use in industrial production.
Use pipe Exact pipe supports to support the pipe.

Product Features

While reading the operating instructions, unfold the
graphics page for the machine and leave it open.
This page is folded under the cover of this manual
(page 3). The following numbering of the product
features refers to this illustration.
1. UNLOCK button
2. Power switch
3. Power-switch locking lever
4. Blade-guard cover
5. Moving blade-guard
6. Edge of moving blade-guard
7. Braking wheels
8. Adjusting wheel
9. Operating handle
10.Blade-guard screw
11.Spindle-lock button
12.Motor unit
13.Blade key and (key for the
adjusting wheel)
14.Rating plate
15. Rpmregulator
16.Gripper unit
17.Gripper adjustment handle
18.Bevel depth adjustment
10
e n g l i s h