Emptying Dirty Water Tank - Dirt Devil Quick & Light Guide D'utilisation

CARPET CLEANING

EMPTYING DIRTY WATER TANK

Your Carpet Cleaner is equipped with a shut off valve within your dirty water tank. When the dirty water tank becomes full,
the blue float (viewed from top of tank) will rise, shutting off the air flow through the nozzle.
To reduce the risk of injury from moving parts- unplug before servicing
2.10 Grasp top of dirty water tank
handle and push latch to release.
2.11 Grasp handle and pull tank out
of base.
2.12 Remove dirty water tank lid.
2.13 To empty dirty water tank,
grasp handle with one hand and
nozzle with the other and empty into
sink. Replace dirty water tank lid.
2.14 Rinse dirty water tank and filter
with hot tap water. Wipe and let dry
thoroughly before storing to prevent
mildew from forming.
(continued)
• For best cleaning results use a steady, forward and backward motion.
Cleaning should be done at half the speed of dry vacuuming. For heavily
soiled areas, repeat if necessary.
• While depressing solution spray trigger, slowly push unit forward.
Release trigger and pull unit backward in the same path to remove
dirty water and solution from carpet. (For heavily soiled areas, repeat if
necessary).
• IMPORTANT: IF THE SOUND OF THE MOTOR CHANGES TO A HIGH
PITCH, THIS INDICATES THE DIRTY WATER TANK IS FULL AND MUST
BE EMPTIED.
WARNING
2.10
2.12
2.14
• IMPORTANT •
2.11
2.13
• IMPORTANT •
Do not use any chemicals when
9
cleaning the tank.