Publicité
1: VINYL TAPE (DISCARD)
2: VEHICLE HARNESS
4: THERMISTOR
(2-P)
CONNECTOR
3: A/C AMPLIFIER
1: VEHICLE HARNESSES
(ONLY FOR 16-P,
OR 16-P AND 24-P)
2: AIRBAG HARNESS
1: AIRBAG ECU
A029463
3: FRONT
2: VEHICLE HARNESS
6: FRONT
5: VEHICLE HARNESS
CLAMP
1: AIRBAG ECU
5: FRONT
6: BOLTS
(M8
20)
4:
CAUTION 5
3: DRIP-PROOF SHEET
(7) REINSTALLTION OF ORIGINAL PARTS
(a) Vinyl tape (discard)
A009242
(b) Connect the vehicle harness to the thermistor
connector.
(c) Connect the vehicle harnesses to the A/C
amplifier.
(d) Vehicle harness clamp
A029138
(e) Airbag ECU
Tightening Torque
17.5 N•m (180 kgf•cm, 13.0 lbf•ft)
WARNING
Before starting work always check the cautions and
warnings for the SRS airbag system.
CAUTION
1. Do not use a dropped airbag sensor.
2. Do not apply shock or force to the airbag
sensor.
3. Check whether the carpet, etc. is not caught
between the mounting surfaces.
4. Wobble the airbag sensor to make sure that
there is no looseness.
5. Check whether drip-proof sheet is warped or is
caught in the connector.
6. After completing the task, use the diagnosis
instrument to check the diagnosis code. Also,
make sure that there are no error codes
displayed, and check that the airbag warning
lamp is off.
- 41 -
00503438E
Publicité
