Glamox Aqua Signal 60 Serie Instructions De Service page 17

The stripped ends of the three-wire cable must be plugged into
the corresponding tension-spring
Note!
The protective conductor (green/yellow) must be placed on all
voltage versions, also 24V!
Connect the red cable to the + pole, the black or blue cable to
the - pole.
24V DC Single tier navigation light
The cables must be connected to the connection terminal
according to the marking.
115V/230V AC Single tier navigation light
Check the function of the navigation lights!
No function of the LED if the connection is wrong!
Close the housing carefully. Tighten the screws evenly
gradually crosswise. See chapter 10.8, torque specification
for the four screws. Ensure that the gasket is in good con-
dition and that the gasket is in the correct position.
Page 17 of 24
terminals.
9420119300_en Rev. 3
en
de
fr