Installation; General Mounting Information - Glamox Aqua Signal 60 Serie Instructions De Service

10 Installation

10.1

General mounting information

en
de
fr
The navigation lights must be installed corresponding to the con-
ditions for the installation of navigation and signal lights, acous-
tic signal systems and manoeuvre signal systems.
The function of the navigation lights is then only ensured and in
compliance with the regulations if the following points are ob-
served during the installation and maintenance: The correct po-
sitioning of the navigation lights on board is derived from the
Collision Prevention Regulations 1972 / COLREG's 1972. The
navigation lights must be installed in and above the keel line or
parallel to it.
Their horizontal plane of symmetry (A) must be parallel to the
load water line (CWL). A direction arrow is be marked on the
navigation lights for this, which must be arranged parallel to the
keel line.
The light outlet must not be covered by parts of the vessel or by
objects or persons situated on board. Their position to the vessel
must not change during the operating duration.
The vertical distance (C) must be at least 4.5 m or be large
enough in all trim positions so that the rear top light can be seen
above and separate from the front top light at 1000 m distance.
Divergent from the regulations of the Collision Prevention Reg-
ulations, the front top light only needs to be placed 5 m above
the ship's hull and the rear top light only at least 3 m above the
front top light for inland waterway vessels.
For navigation lights series 60 and/or 61,
prescribed for the Masthead-, Starboard and Port
lower part of navigation light with mounting screws must always
be directed to the bottom.
All other navigation lights can be mounted overhead.
Page 12 of 24
the upright position is
light. The
9420119300_en Rev. 3