Connection; Unipotential Connection; First Start - OEM FX/201/M Mode D'emploi Et D'entretien

FX / RVE
Installation and connections
3.4.a - Control of a correct electrical connection
(Fig. 5)
For the connection 230/400 V three phase, it is neces-
sary to check if the engine rotation is right, to do this
proceed as follows:
• The cutout switch placed at the machine upper side
shall be positioned on "ON".
• Turn the timer knob (1) to the word "Timer".
• Press the key (2) " ".
• Visually make sure the container (3) rotates according
to the direction indicated by the arrow (4).
Disconnect the machine by pressing "
If the rotation direction is contrary to the arrow direc-
tion, proceed as follows:
DANGER
Before making any change in the electrical connec-
tion, make sure that the DISCONNECTING SWITCH
is disconnected (line not energized), then:reverse
two of the three phase wires on the main switch and
check again the correct rotation.
3.4.b - Unipotential connection (Fig. 5)
The machine is provided with a screw (6) for unipotential

connection.

To make the connection, unscrew the screw nut (6),
connect the cable of the unipotential net to the screw
and tighten the nut again.
3.5 - FIRST START (Fig. 5)
• The cutout switch placed at the machine upper side
shall be positioned on "ON".
• Turn the timer knob (1) to the word "Timer".
• Press (2) " ".
• Let the machine idle for a few minutes and check if
the rotation is regular and free.
• Disconnect the machine by pressing "
Fig. 5
1
" (5)
" (5).
2
5
3
4
6
EN - 13