Reference Normative; Description Of The Symbols - OEM FX/201/M Mode D'emploi Et D'entretien

FX / RB / RVE
General specifications and warning
- It is absolutely prohibited to use the machi-
ne for other purposes different from those
expressly indicated and documented.
The machine should be used always when
and how provided by the good technique, in
compliance with the EEC machine directive
89/392 and in compliance with the regulations
concerning health and safety of the workers,
as indicated by the local regulations or ac-
cording to the EEC directive 89/391.
- The manufacturer declines all responsibi-
lity for any accident or damage to persons
or properties arising from the non com-
pliance with the safety regulations and
the directions of this booklet.
- THESE SAFETY REGULATIONS INTE-
GRATE OR COMPLEMENT THE LOCAL
SAFETY REGULATIONS.
- DO NOT make hurried or inaccurate
repairs that may compromise the good
running of the machine and the safety of
the operator.
- IN CASE OF DOUBT ALWAYS ASK FOR
THE PRESENCE OF SKILLED PERSON-
NEL.
- FOR ANY ELECTRIC/ELECTRONIC OR
MECHANIC TAMPERING OF THE MA-
CHINE BY THE USER OR IN CASE OF A
NEGLIGENT USE OF THE MACHINE, THE
MANUFACTURER IS RELIEVED FROM
ANY RESPONSIBILITY AND THE USER
WILL BE THE ONLY ONE RESPONSIBLE
AGAINST THE COMPETENT AUTHORI-
TIES FOR THE ACCIDENT PREVENTION.

1.2 - REFERENCE NORMATIVE

- The machine and its safety components have been
manufactured in compliance with the directives indi-
cated in the declaration of conformity.

1.3 - DESCRIPTION OF THE SYMBOLS

Many accidents are caused by a poor knowledge of
and by a non compliance with the safety regulations
to put into practice during the functioning and main-
tenance works to be done on the machine.
In order to avoid any accidents, read understand
and follow all the warnings and cautions contained
in this booklet and those written on the plates located
on the machine.
To identify the safety messages included in this bo-
oklet, following symbols have been used:
DANGER
This symbol is used in the safety messages contai-
ned in the booklet in case of potential danger situa-
tions or possibility to cause serious injuries or dead.
ATTENTION
This symbol is used in the safety messages of the
booklet for any danger situation that, if disregarded,
may cause small or moderate injuries or damages.
The message can be used also in case of danger
situations that may cause damages to the machine.
☞
IMPORTANT
This symbol is used in case of precautionary measu-
res to be taken in order to avoid any operation that
may reduce the life of the machine or for important
communication to the operator.
DANGER
For clarity reasons, some illustrations of this booklet
show the machine without safety guards. DO NOT
USE THE MACHINE WITHOUT SAFETY GUARDS.
EN - 3